The following solar LED street light manufacturers summarize the solutions for several solar street lights installation errors. Solution: Before installation, try to stay away from the light source to avoid interference. If it is unavoidable, ensure that there are Customize led street lights Manufacturers no obstructions in the south direction of solar street lights.

 

If you do not pay attention to some important details during the installation process, it will naturally cause the solar street light to not light up normally. The price is naturally much higher than that of cold galvanized. The corners of complex workpieces are prone to 'electric burning' and become grayish, where the zinc layer is thicker.

 

The current dead angle is easy to form in the negative corner, resulting in an undercurrent gray area, where the zinc layer is thinner. In the same way, 'you get what you pay for', solar street lights hot-dip galvanizing are more worth buying. After degreasing and pickling with electrolytic equipment, the workpiece is put into a solution of zinc salt and connected to the negative electrode of the electrolytic equipment.

 

The electroplated layer using the white passivation process is bluish-white or white with green light, and the electroplating layer of the white passivation process is slightly colorful at a certain angle with the sunlight. Compared with cold galvanizing, hot-dip galvanizing has a higher cost and a more complicated manufacturing process than cold galvanizing.. 

Megosztás a facebookon

Generally, there will be no water. Therefore, the key consideration in the design is the connection between the battery module bracket and the solar LED street light pole. In the above formula, r is the inner diameter of the ring, is the width of the ring.If the wind resistance coefficient is selected as 27m/s (equivalent to a tenth typhoon), according to the non-viscous fluid mechanics, the wind pressure on the battery module is only 365Pa.

Therefore, during construction, attention should be paid to bend the internal connecting wire of the controller terminal into a type and fix it, and the connecting wire exposed to the outside shall also be fixed to a type, so that rainwater cannot enter and cause the controller to short-circuit , In addition, waterproof glue can be applied to the inner and outer line interfaces to waterproof.

The wind resistance design is mainly divided into two parts, one is the wind resistance design of the battery module bracket, and the other Outdoor Aluminum Led Light Housing manufacturers is the wind resistance design of the light pole.Anti-theft design of solar LED street lamp system In places far away from the city, you should also pay attention to anti-theft work. The distance between the calculation point P of the resistance moment W of the failure surface of the solar led street light pole and the load F of the solar panel on the pole is PQ = [5000+(168+6)/tan16o; Sin16o =1545mm=1.

Therefore, the component itself can withstand the wind speed of 27m/s without being damaged. However, in some actual engineering cases, the rainwater will run down the outside of the controller terminal because of improper installation. According to mathematical derivation, the resistance moment of the circular failure surface.Wind resistance design of solar LED street lamp system In the solar led street light system, a structural issue that needs to be paid attention to is the wind resistance design. Buried solar led street light batteries with cement is an effective anti-theft measure.  

Megosztás a facebookon